The Warp 9 Racing DR650 Starter Cap is a CNC machined billet starter endcap designed to replace the stock starter bushing setup that can suffer from exhaust heat and minimal factory lubrication. This upgraded starter cover comes with a high speed Abec 3 double sealed roller bearing already installed to provide smoother support at the starter end. By improving bearing support, it helps reduce the amperage needed to start the bike and can extend brush life. Finished in black anodizing for clean looks and corrosion resistance, this starter cap is built specifically to fit DR650 models from 1996 and later.
This starter endcap is CNC machined from billet to deliver a precise, high-quality replacement for the original DR650 starter bushing arrangement. It’s designed as a durable solution for a component that sees heavy wear from heat and limited factory lubrication, helping keep the starter end better supported over time.
A high speed Abec 3 double sealed roller bearing is installed in the cover to improve support and reduce friction compared to a worn bushing. This can reduce the amperage needed to start the bike and helps the starter operate more efficiently, which can also contribute to extended brush life.
The cap is black anodized for good looks while adding a tough protective surface. The clean black finish complements the engine area and helps the part hold up in the harsh environment around the starter and exhaust on the DR650.
The starter bushing in the DR650 leads a tough life due to exhaust heat and minimal lube from the factory. This Warp 9 Racing billet starter cover replaces the stock endcap and upgrades the support point to a sealed ball bearing solution.
| SKU | 91-DRCAP |
|---|---|
| Product type | Starter Caps |
